Bolens 140-830A User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 22.
4.
Swing the belt guard forward towards the
front of the tractor. (See figure 22.)
{ WARN[NG }
Observe the way the belt is twisted.
If
the
new
belt
is
i n s t a l l e d
backwards,
the
tractor
will
run
backwards.
Using a bar or large screw driver, pry the
pulley assembly towards the front of the trac
tor and unhook the belt from the pulley. (See
figure 23.)
6
.
Install the new belt by hooking it over the
engine pulley and twisting the belt to the left
as you attach it to the pulley.
7. Test the operation of the tractor to assure the
belt has been installed correctly.
FIGURE 23.
Removing the Rear (Clutch) Belt
1. Remove the cutting deck and battery.
2. Raise and block the front wheels of the tractor
so you can work under it.
3. Depress the clutch-brake pedal and set the
parking brake.
4. Remove the two belt guard pins on the pulley
assembly. (See figure 24.)
Belt Guard Pins
FIGURE 24.
15