Controls and preliminary checks – Bolens 140-830A User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

11. Replace the round belt guard and swing the

wire belt guard over the engine pulley and
secure it with the “L” bolt.

12. Check all belt guards for clearance. The belt

guards must be between 1/16" and

1

/

8

" away

from the belt when the PTO lever is in the
engaged position.

13. Hook the brake release cable into the tractor

idler bracket and secure it with the small cot­
ter hairpin.

FIGURE 8.

CONTROLS AND

PRELIMINARY CHECKS

CONTROLS
Ignition Switch

The ignition switch is located in the center of the
dashboard. Turn the key to the START position to

start the engine. When the engine is running,
leave the key in the ON position. To stop the
engine, turn the key to the OFF position. (See
figure 9.)

Remove the key from the tractor

when the tractor is not in use to pre­
vent accidental starting.

Throttle Control

The throttle control is located on the left side of

the dashboard and is used to regulate the engine
speed. (See figure

6

.) The engine should be

operated

from

to

full

throttle

(FAST)

when

operating any equipment that uses the tractor
engine as a source of power such as the mowing
deck, snow thrower or rotary tiller. (See figure 9.)

Choke Control

The choke control is located on the right side of
the dashboard and is operated manually. Details
for the choke operation are covered in the Engine
Operating and Maintenance Instructions Manual.
(See figure 9.)

Light Switch

The headlamps are operated by pushing the light

switch located on the dashboard. The headlamps
will only operate when the engine is running. (See
figure 9.)

Ammeter

The ammeter registers the rate of battery charge

or discharge. The ammeter should register on the
plus (H-) side when the engine is running in the

FAST position until the battery is completeiy

charged.

With a fully charged battery or with the engine idl­

ing, the ammeter may not show a charge.

The maximum charging rate is 3 amps. The

headlamps operate directly from the engine alter­
nator and do not register on the ammeter. (See
figure 9.)

FIGURE 9.

Gasoline Tank

The gasoline tank is located under the tractor

seat. Fill the gasoline tank with approximately 1.9
gallons

of

clean,

fresh,

lead-free

or

leaded

“regular” grade automotive gasoline. Tip the seat
forward to fill the tank. (See figure 10.)

Advertising