Bolens 111-338A - Manual (Page 16)

2. Drain all the oil from the crankcase (this
should be done after the engine has been
operated and is still warm). Refill the
crankcase with clean new oil.
3. Disconnect the spark plug wire and remove
the spark plug from the cylinder. Pour about 2
or 3 tablespoons of engine oil into the
cylinder. Turn the engine over several times to
spread out the oil. Replace the spark plug, but
do not connect the wire.
4. Clean the engine and the entire mower
thoroughly.
5. Lubricate ail lubrication points.
A
HANDLE STORAGE
CAUTION
Be careful not to kink or pinch blade
brake/clutch cable when folding the
handle for storage.
1. Remove hairpin cotters from inner hole on
weld pins on handle mount brackets. Place in
outer hole.
2. Loosen the two hand knobs on the inside of
the handle.
3. Push outward on the bottom of each side of
the lower handle, and push forward.
4. Fold the upper handle back and down.
The handle can be stored in an upright position to
take less space. Move hairpin cotters to outer hole
on weld pins (see figure 3). Grasp the lower handle
at the bottom and pull apart slightly. Tip the han­
dle forward. It will lock in this position. Reverse
this procedure to place the handle in the
operating position.
This model may also be folded away completely
for storage.
To take the handle out of storage position, pro­
ceed as follows.
1. Lift the upper handle up and towards the rear.
2. Pull the handle back until it locks into the
operator’s position.
3. Tighten the two hand knobs securely.
4. Move the hairpin cotters to the inner hole on
the weld pins.
16