Grass catcher assembly – Bolens 111-338A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(D)
5. Secure throttle control cable and blade
brake/clutch cable to handle with cable ties
— (D) provided. See figure 5.
6. Check all nuts and bolts for correct tightness.
FIGURES.
Grass Catcher Assembly
Rear
Frame
Front
Frame
Tubing
Connector (I)
1. Join the front and rear frames by pushing the
— ends of the rear frame into the ends of the tub
ing connectors (I). See figure 6.
FIGURE 6.
Start L
Lock Was .
■
and Hex Nu
Leave Bottom
Side Bolts Out
2
.
insert frame into bag (printing on bag is the
top of the bag). Fasten edges (with eyelets) to
front frame with 3/8" bolts (E), lock washers
(F) and hex nuts (G). Finger tighten. See figure
7. Hint: For easier assembly, Do not fasten
lower bolts on sides until after step 3.
FIGURE 7.