Aiphone LAA-1 User Manual

Alphone two-station intercom, Operation, Installation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

AlPHONE

TWO-STATION INTERCOM

MODEL L A A - 1 (SET)

SIMPLE "DO IT YOURSELF” INSTALLATION - EASY TO OPERATE!

LAA-1 (SET)

* Loud-speaking type intercom with volume control. Open voice sub­

station allows hand-free remote reply from anywhere in a room.

* Designed for either desk use or wall mounting (hardware included).

* Electronic tone call signal.

* Power source:

PS-6D (PS-6C in North America) or four Ilf volt “C”

batteries.

* Wiring and communication range: Single pair of wire. Select the

proper wire guage to meet your requirements from the chart below.

Diameter of wire

0.65 mm

0.8 mm

19 AWG

22 AWG

Distance

300 m

500 m

2000 feet

1000 feet

- OPERATION-

MASTER STATION:

1. Depress and hold ''Push to talk” switch during transmission.

2. Release "Push to talk” switch to listen to or monitor substation.

3. To conserve batteries, depress "Off” switch when nat using

system.

4. You may call substation by voice or by call tone. To call by

voice, depress "Push to talk” switch and commence speaking.

To call by call tone, depress "Push to talk” switch and "Off”
switch simultaneously.

5. Adjust volume control for desired volume level.

SUBSTATION:

1. To call master station, momentarily depress "Call” switch.

2. Talk and listen hands free to master. Do not push "Call” switch

during conversation.

- INSTALLATION-

MASTER STATION:

1. Insert 4

1%.

volt

batteries (not included) in battery comp

artment. Direction of batteries is clearly indicated in compartment.

2, Install 2-conductor wire as shown below. Nonpolar unit allows

connection of either wire to either terminal at substation.

VOLUME CONTROL

OFF SWITCH

SPEAKER/MICROPHONE

PUSH TO TALK SWITCH

SPEAKER/MICROPHONE

CALL SWITCH

BATTERY COMPARTMENT

® O

© 0

0

@

0

0

TERMINAL LOCATION

MASTER STATION

TERMINALS

SUBSTATION: Attach two wires from master as shown above.

Advertising