Black & Decker 9013 - Manual (Page 5)

15. DO NOT charge drill when it or air
temperature is BELOW +40°F or
ABOVE +105°F.
16. DO NOT incinerate the drill even if
it is severely damaged or is com­
pletely worn out. The batteries can
explode in a fire.
A small leakage of liquid from the
battery cells may occur under ex­
treme usage, charging or tempera­
ture conditions. This does not
indicate a failure. However, if the
outer seal is broken and this
leakage gets on your skin -
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such
as lemon juice or vinegar.
c. If the battery liquid gets in your
eyes, flush them with clean water
for a minimum of 10 minutes and
seek immediate medical attention.
(Medical Note; The liquid is a 25-
35% solution of potassium hy­
droxide.)
17. The charger is designed to operate
on standard household electrical
power (120 volts AC only). Do not
attempt to use it on any other
voltage!
18. Do not attempt to open the drill
housing.
19. UNPLUG CHARGER WHEN NOT
IN USE.
X
Table 1 RECOMMENDED MINIMUM AWG* SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
YOUR CHARGER'S INPUT RATING IS LESS THAN 2 AMPERES.
AC Input Ratina Amperes AWG* Size of Cord
Equal to or
greater than
But less
than
Length of Cord, Feet
25 50 100 150
0 2 18 18 18 16
‘American Wire Gauge