To turn on the projector, Caution, To turn off the projector – Ask Proxima DP5600 User Manual
Page 24: Moving the projector, Control the projector -23, Using the projector
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
c
USING THE PROJECTOR
TO TURN ON THE PROJECTOR
Connect the projector to a video source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the appropriate
terminals on the side of the projector (See ’’CONNECTING THE PROJECTOR” section on pages 10-17).
Oonnect the projector’s AC power cord into a wall outlet and turn the MAINS ON/OFF switch (located on the back of the
projector) to the ON position. The POWER indicator will light RED, the READY indicator will light GREEN and the cooling
fan will operate.
Press the POWER (LAMP) ON/OFF button on the remote control unit or on the
projector to ON. The POWER indicator light will dim and the other two cooling fans will
operate. The wait display appears on the screen and the count-down starts
(20-19-18-...1). The signal from the video source appears after 30 seconds.
A
CAUTION:
THIS PROJECTOR USES A METAL-HALIDE ARC LAMP. TO EXTEND THE LIFE OF THE LAMP, ONCE
YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.
NOTE: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.
Wait at least 5 minutes before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continues to flash, follow the procedures below:
(1) . Press POWER (LAMP) ON/OFF button to OFF.
(2) . Oheck the air filter for dust accumulation.
(3) . Remove dust with vacuum cleaner (See ”AIR FILTER CARE AND CLEANING” section on page 40.)
(4) . Press POWER (LAMP) ON/OFF button to ON.
If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or service
station.
TO TURN OFF THE PROJECTOR
Press the POWER (LAMP) ON/OFF button on the remote control unit or on the
projector. The ’’POWER OFF ?” appears on the screen. Press again the POWER
(LAMP) ON/OFF button to turn OFF the projector. The POWER indicator will light
bright and READY indicator will turn off. The two cooling fans will operate for 1 minute
after the projector is turned off. (During this ’’cooling down” period, the projector cannot
be turned on.) The READY indicator will light green again and the projector may be
turned on by pressing the POWER (LAMP) ON/OFF button.
POWER OFF ?
—
24
—