Cortelco 2750 - Manual (Page 29)

24
To set the Pickup Delay
a.
Press MENU
b. Press DOWN ARROW repeatedly until “Answer Setting” appears in the display.
c. Press the soft key under ENTER. “Ans System: ON” will appear in the display.
d. Press DOWN ARROW repeatedly until “Pickup Delay” appears in LCD Display.
e. Press the soft key under CHANGE repeatedly for the setting you desire (1 to 7 rings)
f. Press MENU to exit.
5.1.4 Setting Toll Saver
The Toll Saver feature helps eliminate toll charges when calling in to check for messages. When Toll
Saver is turned ON, the answering system will pick up incoming calls after the second ring if there are
new messages, or after the fourth ring if there are no new messages. To avoid toll charges, hang up
after the third ring.
Note: The Toll Saver feature overrides the Answer Pickup Delay setting. Also, if this phone is set as an
Auto Attendant, the Toll Saver overrides the Auto Attendant Pickup Delay setting. If Auto Attendant
Pickup Delay is set to 0 rings, Toll Saver must be OFF.
To Set the Toll Saver Feature ON or OFF follow the directions below.
a.
Press MENU
b. Press DOWN ARROW repeatedly until “Answer Setting” appears in the display.
c. Press the soft key under ENTER. “Ans System: ON” will appear in the display.
d. Press DOWN ARROW repeatedly until “Toll Saver:OFF” appears in LCD Display.
e. Press the soft key under CHANGE to turn ON or OFF
f. Press MENU to exit
5.1.5 New Message Beep
The 2750 may be set to beep once every 60 seconds when there are new messages in its answering
system. To set the New Message Beep follow the directions below.
a.
Press MENU
b. Press DOWN ARROW repeatedly until “Answer Setting” appears in the display.
c. Press the soft key under ENTER. “Ans System: ON” will appear in the display.
d. Press DOWN ARROW repeatedly until “New Msg Beep: OFF” appears in LCD Display.
e. Press the soft key under CHANGE to turn ON or OFF
f. Press MENU to exit
5.1.6 Remote Code
The Remote Code allows the Answering System to be checked from a distant location. The Remote
Code is set to 1234 at the factory. Follow the instructions below to change the Remote Code. If you
ever forget your code, simply set a new one at your telephone.