Xoro HSD 4000 User Manual
Page 116
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTES ON SERVICE
Check the following guide for the possible cause of a problem before contacting service.
Technical Support of Xoro/MAS: Tel.: 040/77 11 09 17, Internet:
Symptoms
Cause
Correction
No power
The power plug is disconnected
Connect the power plug Into the wall outlet
No picture
The TV Is not set to receive DVD
signal output
Select the appropriate video input mode on
the TV so the picture from the DVD player
appears on the TV screen
The video cable Is not connected securely
Connect the video cable Into the jacks
securely
The DVD video mode Is not matched
with the TV
Refer to Connecting toaTV(page 10)
The audio cable Is not connected securely
Connect the audio cable Into the Jacks
No sound
The power of the equipment connected with
the audio cable Is turned off
Turn on the equipment connected with the
audio cable
The setting of output sound type is not correct.Set the audio setting correctly.
The playback picture
has occasional
The disc is dirty.
Eject the discs and clean It.
It Is In fast fonward or fast reverse playback. Sometimes a small amount of picture
distortion may appear. This Is not
malfunction.
Brightness is
unstable or noises
are produced on
playback pictures
The copy protection’s effect.
Connect the DVD player to the TV directly.
The DVD player
does not start
playback
No disc Is Inserted.
Insert a disc.
An unplayback disc Is Inserted.
Check the disc type and color system.
The disc Is placed upside down.
Place the disc with the playback side down.
The disc Is not placed within the guide.
Place the disc on the disc tray correctly
Inside the guide.
A menu Is on the TV screen.
Clean the disc.
The parental lock function Is set.
Press the SETUP button to turn off the menu
screen. Cancel the parental lock function or
change the parental.
Buttons do not work
Power supply fluctuations or other
abnormalities such as static
electricity may Interrupt correct
Turn the power on or off with the POWER
button. Or disconnect the power plug and
Insert it Into the wall outlet again.
The remote control
does not work
properly
The remote control is not pointed at
the remote sensor of the DVD player
Point the remote control at the remote
sensor of the DVD player
The remote control is too far from
the DVD player
Operate the remote control within
about 7 m
The batteries In the remote control
are exhausted
Replace the batteries with new ones