Aiphone My-Cu - Manual (Page 12)

BEFORE ASKING FOR REPAIR
★ In case the system does not provide a satisfactory performance, possible causes may be; Unplugged? Disconnected wire?
Shorted wire? Consult the dealer or distributor that you purchased the product from.
★ Refrain from spraying water at the door staton directly, regardless that the unit Is designed to be weather-resistent.
★ Clean your MY-CU equipment by a soft cloth dampened with neutral household cleanser.
★ When the temperature outside lowers rapidly (after rain, etc.), the camera lens may be fogged and offer a dim Image at the
video monitor. This is not a malfunction, and will return to normal shortly.
I
SPECIFICATIONS ----------------
Power source DC 18V on MY-CU
Use a PS-18D power supply (PS-18C in North America).
Current consumption
Pan/tilt viewing area shown by dotted line
System MY-CU MYH-CU 3-monitor
Max. 0.9A 0.4A 1.7A
Standby 0.12A OA 0.12A
Video monitor
Scanning line
PanTilt door capacity
4” direct view flat CRT
525 lines
130cm
(4'3")
Camera
center
1 door lE-IGD(U), IE-2AD(U), IE-8MD, TD-H/Aor B, MYW-P1L (LEF)
2 doors MYW-P3CB (for IE, TD-H/A or B)
3 doors MYW-P3L (LEF)
4-,
12cm (5”)
2ecm (If)
200cm (67’)
171cm (5’8’
90cm (36’’)
-122cm (4’)
110cm (3’8’
MY-DC/DG
157cm (22”)| 66cm (26”) i57cm (22”)|
c--------------- 1-180cm (6’)(----------------- -i
0cm
50cm
( 20 ”)
6cm 50cm (20”)
Wiring Use 6 or 8-conductor (non-twisted) cable between monitors with no extra wires nor reconnections.
: Viewing area of camera in stili position
To Pantilt door
MY-DC MY-CU
2 cond. (parallel)
0.65mm^ 50 m
0.8mm 70m
1.0mm 95 100m
22AWG 165’
20AWG 230’
18AWG 330’
2 monitors
MY-CU MYH-CU
0.65mm.^ 35m
0.8mm ÿ 50m
I.Omm^ 75m
22AWG 115’
20AWG 160’
18AWG 250’
' 3 monitors
MY-CU MYH-CU MYH-CU
0.65mm ^ 17m
0.8mm.# 25m
1.0mm(# 45 m
22AWG 55’
20AWG 80’
18AWG 145’
3 monitors
MY-CU MYH-CU MYH-CU
Wires on each -1-, - are doubled.
0.65mm # 35m
0.8mm .# 50m
1.0mm (f 75m
22AWG 115’
20AWG 160’
18AWG 250’
Dimensions (H x W x D)
Weight (approx.)
210 mm X 155 mm x 50 mm. 8-1/4” H x 6-1/8” W x 2” D
MY-CU 1.0 kg (2.20 lbs.) MYH-CU 0.9 kg (1.98 lbs.)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular Installation. If this equipment does cause harmful inteference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician tor help.
-t*
•t-
-t-
4*
4-
-t-
4-
4-
4*
4*
4-
4-
4-
4-
4-
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of two
years after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which
examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final decision
whether there is a defect in materials and/or workmanship; and whether or not the product Is within the warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of
instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover
batteries or damage caused by batteries used in connection with the product.
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls.
**}*-i*-^-.i*
-h
Aiphone Co., Ltd., Nagoya, Japan
Aiphone Corporation, Bellevue, WA, USA
IVIY-CU-I(E) 0595D
COMMUNICATION SYSTEMS &
AIPHONE
— HOME, BUSINESS. INDUSTRY.
Printed in Japan (E)
-12