Parts needed for • floor frame assemblies, Step 1, Floor frame assemblies – Arrow Storage Products 697.68222 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Step 1
• Parts Needed For •
Floor Frame Assemblies
#8934 Ramp(1)
• 9367 Front Floor Frame (2)
• 8936 Rear Floor Frame (2)
• 10392 Side Floor Frame (4)
The front floor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made up
of two pieces. The holes in these
pieces will align when the pieces are
positioned with correct amount of
overlap. The illustrations below show
the properoverall length forthe sides,
rear and front. Proceed as follows:
1
Place the
front floor frames as
shown. Center the
ramp, with drain
holes facing outside, on top of the two
front floor frames. Join the frames by
inserting eight screws.
2
Overlap the
side floor frames and
the
rear floor frames as shown. The
holes in these pieces will align when
the pieces are positioned with cor
rect amount of overlap. See the illus
trations below for the proper overall
length ofthe side and rearfloorframes.
Join the frames by inserting four/five
bolts into each frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
Front Floor
Frame Assembly
119 3/8" 303,2cm
'DRAIN HOLES FACE«
OUTSIDE
Side Floor Frame 141 5/8" 359,7cm
10392
Rear Floor Frame 119 3/8"
303,2cm
8936
141 5/8" 359,7cm
Sides
141 5/8" 359,7cm
3/8" 303,2cm
Front & Rear
303,2cm
14