Arrow Storage Products 697.68222 - Manual (Page 27)

Step 14
• Parts Needed For •
Right Roof Panel
• 10510 Right Roof Panel (1)
WP27
Installing the roof panels is best done
with a step ladder. Install the first roof
panel at the back right corner of the
building. Each screw and bolt in the
roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fit better, and holes will
align. Don't anchor the floor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate the roof panels and find
the right roof panel part number
10510.
2 Position a right roof panel at the
back right corner and fasten to the top
roof beam using screws.
g ----------------i—
•
10510
\
(8) Screws
STEP
STEP STEP STEP
3 4
Hint: Follow the fastener sequence
shown for proper alignment.
3 Remove edge trim from the left
gable under the roof panel.
4 Continue fastening the right roof
panel to the gable and lower roof
beam using screws, bolts and nuts
as shown. Do not fasten
the lower end of the
panels to the side
wall angles at this
time.
10510 Right Roof Panel
1 thru 4
FRONT
27