Step 3, Roof beam assemblies – Arrow Storage Products 697.68222 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Step 3
• Parts Needed For •
• 10397 Roof Beam (8)
Roof Beam Assemblies
SV16
The roof beams join the two gables
and support the roof panels. The main
roof beam is made up of four pieces
overlapped back to back at the cen
ter. The left and right roof beam as
semblies are made up of two pieces.
Hint: These pieces are force-fitted,
so you may have to press hard to join
them together.
1
Place one end of a roof beam
inside another roof beam so that the
six holes in each piece align. Make
four sets of roof beams by repeating
this procedure.
Do not insert bolts
vet.
2
Take two of the pressed-together
roof beams and join them as shown
to form the main roof beam assembly.
Hold the assembly together and fas
ten with 14 bolts. Build
only one
Doubled Beam Assembly.
3
Fasten the other two pressed-
together roof beams with eight bolts
to make the left and right roof beam
assemblies.
4
Set these pieces aside for later
assembly.
142 3/8" 361,6cm
Build
one
Doubled Main Roof
Beam Assembly for Peak in Roof
142 3/8"
361,6cm
Build
two
Single Beam
Assemblies
142 3/8"
361,6cm
16