Arrow Storage Products 697.68222 - Manual (Page 28)

Step 15
• Parts Needed For •
Ridge Caps & Panels
10511 Left Roof Panel (1)
'6538 Roof Panel (2)
' 6869 Ridge Cap (3)
1
Install a left roof pane! 10511 at
the left rear corner of the roof.
2 Cut 28 short 3"(7,6cm) strips off the
small roll of weather stripping tape,
and put them aside. Coverthe joint at
the peak with weather stripping tape,
large roll. Unroll the tape and press it
down over the opening at the ridge as
you install each roof panel. Do not cut
the tape at this time.
3 Install two roof panels 6538 work­
ing side to side. Fold the lower sec­
tion of the roof panels down. Cover
the notches with the strips of weather
stripping tape. Save the rest.
Do not
fasten the lower end of the panels to
the side wall angles at this time. Con­
tinue weatherstripping the ridge open­
ing.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible
4 Install three ridge caps 6869 on
the completed roof section using bolts
and nuts. Do not fasten the ends of
the ridge caps at this time.
5 Fasten the roof panel ribs, peak
caps and ridge caps together using
bolts and nuts.
Screws To
Roof Beam
?
&
Fasten at ^
Overlap With ®
Bolt
Screws To
Roof Beam
^ Fasten At
Overlap With
Bolt
Do not fasten
at this time
STEP
STEP STEP
1
6869
\
1 r'CiC^rs
5
F
ront
28