Aiwa XR-M1000 - Manual (Page 4)

PREPARATIONS
CONNECTION
Check your system and accessories
(D
ф DX-NM1000 Compact disc player
@ FX-NM1000 Stereo cassette deck
@ GE-NM1000 Graphic equalizer
@ MX-NM1000 Stereo receiver
® SX-NMT1000 Front speakers
Remote control AM antenna FM antenna
Operating Instructions, etc.
Setting up the units
Place the units horizontally as the illustration above.
When placing them vertically, refer to the illustration as follows. •
• Do not place the stereo cassette deck on the CD player. The
top window of the CD player may be damaged.
• Make sure that the stereo cassette deck is placed on the left
side of the stereo receiver.
It may generate some noises or may prevent the stereo system
from proper functioning if the stereo cassette deck is placed on
the right side of or on the stereo receiver, or if the stereo receiver
is placed on the stereo cassette deck.
IMPORTANT
Connect the speakers, antennas, and all optional equipment first.
Then connect the AC cord in the end.
Before connecting the AC cord
The rated voltage of your unit shown on the rear panel of the
stereo receiver is 120 V AC. Check that the rated voltage matches
your local voltage.
Speakers
The speaker placed on the right side of the unit facing you is
“the right speaker” and the other one is “the left speaker”.
1 Connect the flat cables of DX-NM1000 © , FX-
NM1000 ® and GE-NM1000
(D
to MX-NM1000.
Push the connector until it clicks.
2 Connect the speaker cords to the SX-NMT1000
front speakers.
Connect the cords with the white stripes to ® terminals and
the other cords to © terminals.
3 Connect the speaker cords to MX-NM1000.
Connect the cords with the white stripes to © terminals and
the other cords to 0 terminals.
0
4
ENGLISH