Aiwa NSX-A10 - Manual (Page 13)

Within 4 seconds, select the duration for the
timer-activated period with the DOWN or I
UP button.
■ ' ' l'>'l L. I..I ■ ■
I _i_ I I \
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
• if this step is not compieted within 4 seconds, repeat from
step 1.
5 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6 Press the POWER button to turn the unit off after
adjusting the volume and tone.
© remains on the display after the power is turned off (fimer
standby mode).
7 Get ready for the TAPE function or the timer
recording.
To listen to the tape, press the ► button.
To record the source, press the • button on deck 1.
When the timer-on time is reached, the unit turns on and
begins play with the selected source. While the timer is in
operation, the display indication is dimmer than usual.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the
timer recording period, the • button on deck 1 is released before
the timer is off.
When the tape length is longer than the timer recording period,
the # button is not released. If the • is not released for a long
time, the tape in the deck may be damaged. Press the K/±
button to release the • button.
To cancel the timer standby mode temporarily
While pressing the SHIFT button, press the TIMER button so
that 0 goes out in the display.
To restore the timer standby mode, press the TIMER button while
pressing the SHIFT button to display 0.
If using the unit after setting the timer
After setting the timer, you can use the unit. After using the unit,
check whether the contents in steps 5 and 6 are set as you wish,
turn off fhe power and set step 7 if necessary.
To change the specified time and function
Repeat all the steps again.
To check the specified contents
While pressing the SHIFT button, press the TIMER button. The
timer-on time is displayed for 4 seconds.
SETTING THE SLEEP TIMER
I l|'" y9>
c:z
|—2
|o
.C.
r V Q)
cc
UJ
s
F=
Q
Z
<
u
o
i-'
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press the SLEEP button while pressing the SHIFT
button.
!-
2 Within 4 seconds, press the ◄◄ or ►► button
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
■ Specified time
I I i i I I
II I"' I r
While the timer is in operation, the display indication is dimmer
than usual.
To check the time remaining until the power is turned off
Press the SLEEP button once while pressing the SHIFT button.
The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice while pressing the SHIFT button
so that “SLEEP” on the display disappears, •
' Timer playback and timer recording will not begin unless the
power is turned off.
' Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
ENGLISH
1 2