Denon AVR-2801 - Manual (Page 10)

ENGLISH
10
IN
IN
OUT
SIGNAL
GND
DVD
EXT. IN ANTENNA
VDP
TV/
DBS
VCR-2/
V.AUX
COAXIAL
VCR-2/
V.AUX
CDR/
TAPE
CDR/
TAPE
VCR-1
VCR-1 OPT.-1
OPT.-2
OPT.-3
FR
LOOP
ANT.
AM
FM
COAX.
75
SW
SR
CD
PHONO
FL
C
SL
SPEAKER SYSTEMS
AUDIO DIGITAL C-VIDEO
MONITOR
S-VIDEO
PRE OUT
L
R L
R L
R L
R L
R L
R
B R A
FRONT
SURROUND CENTER FRONT FRON
SUB
CENTER
WOOFER
VOLTAGE SE
115V
9kHz
L
R
L
R
Connecting the external input (EXT. IN) jacks
• These input jacks are for inputting multi-channel audio signals in high definition MUSE 3-1 format, multi-channel audio signals from an MPEG
multi-channel decoder, or future multi-channel sound format, etc.
• When making connections, also refer to the operating instructions of the other components.
When connecting a high definition (MUSE 3-1 format)
component, use a separately sold mono/stereo cable if the
surround channel output is monaural.
Front Surround Subwoofer Center
Speaker system connections
• Connect the speaker terminals with the speakers making sure that
like polarities are matched ( ≈ with ≈ , √ with √ ). Mismatching of
polarities will result in weak central sound, unclear orientation of
the various instruments, and the sense of direction of the stereo
being impaired.
• When making connections, take care that none of the individual
conductors of the speaker cord come in contact with adjacent
terminals, with other speaker cord conductors, or with the rear
panel.
NOTE:
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
Speaker Impedance
• Speakers with an impedance of from 6 to 16
Ω
/ohms can be
connected for use as surround and center speakers.
• Speakers with an impedance of 6 to 16 Ω /ohms can be connected
for use as front speakers.
• Be careful when using two pairs of front speakers (A + B) at the
same time, since use of speakers with an impedance of less than
8
Ω /ohms will lead to damage.
• The protector circuit may be activated if the set is played for long
periods of time at high volumes when speakers with an impedance
lower than the specified impedance are connected.
Connection the speaker terminals
1. Loosen by turning
counterclockwise
2. Insert the cord. 3. Tighten by turning
clockwise.
Connecting banana plugs
banana plug
Turn clockwise to tighten, then insert the
banana plug.
LINE OUT
Decoders with 6-channel analog
outputs, etc.