Installation manual | visix ptz network camera, Figure 2-­‐17 remove the protective accessory, Figure 2-­‐18 draw and cut hole on the ceiling – 3xLOGIC VISIX Camera User Manual

Page 22

Advertising
background image

Installation  Manual  

|  VISIX  PTZ  Network  Camera  

 

10225  Westmoor  Drive,  Suite  300,  Westminster,  CO  80021  |  www.3xlogic.com  |  (877)  3XLOGIC

 

 

22  

Figure  2-­‐17 Remove  the  Protective  Accessory  

 

4) Drill  a  hole  on  the  ceiling  according  to  the  drill  template  (supplied).  

NOTE:

 

±

2mm  of  the  diameter  of  the  circle  is  tolerable.  

 

 

Figure  2-­‐18 Draw  and  Cut  Hole  on  the  Ceiling  

 

5) Connect  the  cables.  

The  cables  have  been  connected  to  the  corresponding  interfaces.  Connect  the  power  cable  and  the  red  LED  indicator  
turns  on  when  the  power  is  on.    

NOTE:

 Please  turn  the  power  off  after  checking  the  speed  dome.  

6) Install  the  speed  dome.    
 
Steps:  

1)

Loosen  the  two  lock  screws  on  both  sides  of  the  back  box  and  make  the  locks  in  internal  position,  as  shown  in  
the  following  figure:  

 

Lower  Dome  

Protective  
Foam  

Sticker  

Back  Box  

Lens  Cover  

Advertising