Datamax E-Class E-4304 - Manual (Page 40)

30 E-4203/E-4204/E-4304
+
Problem
Description
Possible
Cause
Solution
Tear Mode selected
but label stop
position (present
position) is not far
enough forward. Another present
position has been
determined.
Enabling the
Present Sensor
causes the label
stop position
(present position)
to be
approximately
0.1” behind the
peel bar.
~OR~
The Present
Adjust value is
not correct.
Ø Disable the Present Sensor.
~OR~
Ø
Ensure the host computer is not
providing a Present Distance
shorter than is required for the
Tear Bar.
Ø Use the Menu Setup to modify
the Present Adjust value.
Tear Mode selected
but label stop
position (present
position) is too far
forward. Another present
position has been
determined.
~OR~
The Present
Adjust value is
not correct.
Ø Ensure the host computer is not
providing a Present Distance
longer than is required for the
Tear Bar.
Ø Use the Menu Setup to modify
the Present Adjust value.
FAULT LED
illuminates during
label alignment The label supply
is empty
Ø Load new label stock