Desa V)CD36RN - Manual (Page 37)

www.desatech.com 116035-01E 37
CLEANING AND
MAINTENANCE
WARNING: Turn off fireplace
and let cool before cleaning.
CAUTION: You must keep
control areas, burners and
circulating air passageways of
fireplace clean. Inspect these
areas of fireplace before each
use. Have fireplace inspected
yearly by a qualified service
person. Fireplace may need
more frequent cleaning due to
excessive lint from carpeting,
bedding material, pet hair, etc.
GLASS DOOR
WARNING: Handle glass
door panel with care. Do not
strike, slam or otherwise abuse
glass. Do not operate fireplace
with the glass door unlatched,
removed, cracked or broken.
WARNING: Do not use abra-
sive cleaners as this may damage
glass. Use a nonabrasive house-
hold glass cleaner to clean glass.
Do not clean glass when hot.
Glass must be cleaned periodically. During start-up
it is normal for condensation to form on the inside
of the glass causing lint, dust and other airborne
particles to cling to the glass surface. During initial
start-up a slight film may form on the glass due to
paint curing. The glass should be cleaned several
times with a non-ammonia, nonabrasive household
cleaner and warm water after the first two weeks of
operation. Thereafter, clean the glass two or three
times during each heating season, depending on the
usage and circumstances present. Refer to Remov-
ing/Replacing Glass Door, page 29 of this manual
when removing glass door for cleaning.
WARNING: Only parts sup-
plied by the manufacturer should
be used when replacing broken
or damaged glass door panel
(see Replacement Parts, page
44). This glass door panel is
a complete unit. No substitute
materials may be used.
CAUTION: Wear gloves and
safety glasses while handling or
removing broken glass. Do not re-
move if glass is hot. Keep children
and pets away from glass.
If glass has been broken, carefully remove glass
door (see Removing/Replacing Glass Door, page
29). Vacuum all glass pieces with a shop vac.
CAUTION: Do not vacuum if
pieces are hot.
Use only the tempered glass door replacement
intended for this fireplace (see Replacement Parts,
page 44 for detail on ordering). No substitutions
may be made. See Removing/Replacing Glass
Door, page 29 for instructions for replacing
glass door.
WARNING: Do not operate
fireplace with the glass door
unlatched, removed, cracked
or broken.
PILOT AND BURNERS
• Remove ember material before cleaning burners
and replace when cleaning is complete.
• Burner and controls should be cleaned with
compressed air to remove dust, dirt or lint.
• Use a vacuum cleaner or small, soft bristled
brush to remove excess dust, dirt or lint.