3 input signal jumper setting, Input signal jumper setting – ADLINK cPCI-7252 User Manual
Page 23
Advertising
Installation
13
2.3 Input Signal Jumper Setting
Note:
This section is for PCI-7250, PCI-7251 and LPCI-7250 only.
There are 8 jumpers (JP1 to JP8) on the PCI-7250, PCI-7251 and
LPCI-7250; each associated with one digital input to configure that
channel as either AC-Filtered or Non-AC-Filtered. Digital input
channels and corresponding jumpers are listed in the table below
The default setting for the input signal selection is Non-AC-Filter
(DC signal input), which is shown as below:
JP1
JUMPER INPUT SIGNAL
JP1
DI0
JP2
DI1
JP3
DI2
JP4
DI3
JP5
DI4
JP6
DI5
JP7
DI6
JP8
DI7
Table 2-1: Jumpers and DI Channels
Input Signal Selection
Non-AC-Filter
(DC Signal)
AC-Filter
(AC Signal)
Jumper JP1 - JP8
2-3
1-2
Table 2-2: Input Signal Selection Jumper Settings
Advertising