ADLINK C514 User Manual
Page 37
Installation
• 31
4.
If you install two same type serial communication cards with jumper
ON or OFF simultaneously, we can not confirm that both cards will
active properly.
5.
If you install multiple cards in one 95/98 system simultaneously,
please confirm that the COM port number assigned do not overlap
for different card. Or you may have improperly operation in your
system.
6.
For easy to maintain 95/98 system’s COM port number, we suggest
that you must set the jumper ON for the first card to be installed in
95/98 system.
7.
The serial communication card can be used in interrupt shared
mode. PCI BIOS will assign IRQ for each serial communication
card. For multi-card application, we can just share one IRQ in each
card, but you must confirm that one system may have minimum one
IRQ left for P&P function. If there are no IRQ left to be assigned to
serial communication card, yo u might have wrong operation.
2.5.3
UNIX/XENIX Installation
Under the UNIX/XENIX operation system, the serial communication card is
an extra peripheral device. A device driver should be linked with the kernel
to build a new kernel system. The serial communication system will work
after the new kernel system is restarted.
The installation environment could be
1.
IBM PC/AT X86 or other compatible machine.
2.
UNIX system V release 3 releases 4 or SCO XENIX system V.
3.
Under the above environment, all the link kit packages should be
installed completely.
Files in the installation diskette have
1.
/etc/PCIIOP/README
2.
/etc/PCIIOP/build
3.
/etc/PCIIOP/d1