ADLINK C514 - Manual (Page 42)

36
• Installation
“map =” denotes the mapping address and memory space of dual port RAM,
should be assigned by PCI bus.
“dram =” denotes the PCIIOP interface card’s built-in memory space.
“ports =” denotes the number of ports, which should be octal of the number
of expansion boxes.
When the above message appears and all of the LED in F641/F642
expansion boxes light on, it means the communication interface controller
has been installed successfully.
If the message of “map =” or “ports =” is not correct (including no message)
or any of the LED in F41/F641 box is not on, you should proceed error
detecting and correcting procedure as follows:
1. Shutdown the operating system, turn off the power.
2. If you can not boot the system successfully, please check the
voltage level. If the voltage level is too low to boot the system, check
the number of controller card and F641/F642 box.
3. Insure the controller interface card has been inserted correctly at
system expansion slot. Insure the DB37 cable has been connected
correctly between controller card and F641/F642 box.
4. Check the memory mapping setting and insure that it does not
conflict with other device’s memory mapping.
5. Check the PCI bus clock is 33 MHz a nd 5V slot. Some main board
manufacture may set to higher PCI frequency.
6. Turn on the power and reboot the operating system. If you can
insure the device driver is well installed, it is not necessary to
re-execute the software installation procedure. Otherwise you may
need to re-execute the software installation procedure.
7. If the message does not indicate correctly, please repeat previous
procedure or contact your supplier.