ADLINK aTCA-9700 - Manual (Page 23)

23
3.3.4 Serial Port
Two serial ports are output to USB Mini-B connectors on the front panel for use as service
terminals. The port labeled IPMI is an "IPMC" debug port and the port labeled CPU" is
connected to COM 1 of the Super IO chip.
Serial Port Pin Definition (USB Mini-B)
PIN Signal Name In/Out
1 Signal Ground
2 Transmitted Data (TxD) Out
3 Received Data (RxD) In
4 Signal Ground
5 Signal Ground
3.3.5 Onboard SATA Interface
The aTCA-9700 has one 7-pin SATA connector reserved for onboard mounting of a Serial
ATA disk on module (DOM). The SATA connector pin list is shown as below.
SATA Pin Definition (7-pin)
Pin Signal Names
1 GND
2 SATA0_TX-P
3 SATA0_TX-N
4 GND
5 SATA0_RX-N
6 SATA0_RX-P
7 GND
The aTCA-9700 is equipped with a SATA flash module (16GB, up to 128GB available)
which supports a SATA 3.0Gb/s interface with sustained read to 122MB per second and
sustained write up to 119MB per second.