ADLINK aTCA-9700 - Manual (Page 34)

34
4.2 IPMI Commands
The following table presents all the commands which are supported by the aTCA-9700 in
different interfaces and compatible with IPMI v1.5 and PICMG 3.0 R2.0 ECN001.
There are two interfaces implemented with IPMI command support.
(1) KCS: OpenIpmi; (2) IPMB0: IPMBa & IPMBb
KCS IPMB0
IPMI Command
IPM Device “Global” Commands
Get Device ID ● ●
Cold Reset ● ●
Warm Reset ● ●
Get Self Test Results ● ●
Get Device GUID ● ●
IPMI Messaging Support Commands
Set BMC Global Enables ● ●
Get BMC Global Enables ● ●
Clear Message Flags ● ●
Get Message Flags ● ●
Get Message ● ●
Send Message ● ●
Master Write-Read ● ●
BMC Watchdog Timer
Reset Watchdog Timer ● ●
Set Watchdog Timer ● ●
Get Watchdog Timer ● ●
Chassis Device Commands
Chassis Identify ● ●
Set System Boot Option ● ●
Get System Boot Option ● ●
Event Commands
Set Event Receiver ● ●
Get Event Receiver ● ●
Platform Event ● ●
Sensor Device Commands
Get Device SDR Info ● ●
Get Device SDR ● ●
Reserve Device SDR Repository ● ●
Get Sensor Reading Factors ● ●
Set Sensor Hysteresis ● ●
Get Sensor Hysteresis ● ●
Set Sensor Threshold ● ●
Get Sensor Threshold ● ●
Set Sensor Event Enable ● ●
Get Sensor Event Enable ● ●
Rearm Sensor Events ● ●
Get Sensor Event Status ● ●
Get Sensor Reading ● ●
FRU Device Commands
Get FRU Inventory Area Info ● ●
Read FRU Data ● ●
Write FRU Data ● ●