ADLINK CoreExpress-ECO2 - Manual (Page 24)

TME-CEM-ECO2-Rev0V4.doc Rev 0.4 Page 20
Trouble Shooting BIOS Settings
It may happen that the BIOS is so badly configured that the CoreExpress-ECO2 does not start at all.
To repair this, the default values of the BIOS can be automatically loaded at boot time. This is
commanded by pulling CoreExpress pin B95 to ground before the system is turned on. Holding this
level and turning the system on loads the default values.
4.2 Drivers
There are drivers for different operating systems for sound, Ethernet and graphics controller
available.
These drivers can be downloaded from LiPPERT's website http://www.lippertembedded.com.
For installation follow the instructions that come with the drivers.