ADLINK Hurricane-QM57 - Manual (Page 12)

SME-LEMT-R0V8 Revision 0.8 Page 8 of 22
Each line contains the address of the first byte of this line, followed by 16 data bytes (displayed as
hexadecimal values, prefixes “0x” omitted for better readability) followed by the corresponding
printable ASCII characters.
The button opens the Write memory dialog box.
Write Memory
Address
The address is entered as hexadecimal value within the range of 0x0000..0x01FC (respectively
0x03FC for 1k board variants).
Size
The size can be any multiple of four, up to 32 bytes or “Auto”.
In Auto-mode, the number of bytes to write is determined by the amount of data entered in the data
field below (max 32 bytes).
Pad
If the data length is not a multiple of four, the required number of pad (or fill) characters is
appended.
In String-mode, a valid pad character can be any printable ASCII character or one of the predefined
pad characters:
- SPACE character (ASCII character 0x20)
- NULL character (ASCII character 0x00)
In Hex-mode, any eight bit hex value (00..FF) is valid.
Mode
Currently supported modes are String and Hex.
String mode: The entered text (up to 32 characters) is converted to a byte stream. Please note that
no termination character is appended.
Hex mode: Up to 64 hex digits (0..9, A..F) can be entered, resulting in up to 32 bytes of data.