Cisco BBSM 1 - Manual (Page 11)

2-11
Cisco BBSM Hotspot 1.0 User Guide
78-15293-01
Chapter 2 Setting Up BBSM Hotspot
Running the Setup Wizard
– After the question asking if you want to change your IP addresses, click No to ignore the
connectivity issues and continue with the setup. A warning message pops up to tell you that you
must resolve the IP address issue for BBSM Hotspot to work properly. (See
Figure 2-9 .) You
are then taken to the Enter Network Device Configuration Parameters window.
(See
Figure 2-10 .)
– Click Cancel to stop the setup.
Figure 2-8 Test Failure Window
Figure 2-9 You Must Resolve This Issue Dialog Box
Step 11 Click Next. The Enter Network Device Configuration Parameters window appears. (See Figure 2-10 .)