Bonaire 3 Star Mid Efficiency - Manual (Page 9)

3 S TAR M ID E FFICIENCY D UCTED G AS H EATER .
Page 9
Problem Solving
Problem Solving
Central Heater will not operate!
Question Y/N Solution
Yes Refer to question 4 1. Has the unit been run
since installation?
No Check the unit is turned on at the power point and the gas cock
is turned on. Call the installer to commission the unit.
Yes Refer to question 3 2. Is the unit installed in a
new home?
No Refer to question 4
Yes Refer to question 4 3. Has the installer run the
unit?
No Check the unit is turned on at the power point and the gas cock
is turned on. Call the installer to commission the unit.
Yes Press the reset buttons or turn the unit off then on to reset unit.
If the unit still does not start call for service. (refer to solution 6
for reset instructions) 4. Is the set temperature
greater that the room
temperature?
No Increase the set temperature so the thermostat calls for heat.
Yes The heater may be programmed to be OFF. To operate the
heater manually press the Manual / Auto button until the
MANUAL is displayed. Adjust the room thermostat greater
than set temperature. 5. Is the thermostat in
program mode?
(Electronic Controller
only)
No Adjust the room thermostat greater than set temperature.
Yes Reset the unit. This can be done by:
1. Turn the power OFF the ON at the power point
2. Turn the control to OFF
3. Pressing the reset button on the circuit control board
6. Has there been a known
power surge?
No Unit should operate normally. If not a service call will be
required.
THIS TROUBLE SHOOTING GUIDE IS A REFERENCE ONLY.
FOR SERVICE OR WARRANTY REQUIREMENTS PLEASE REFER TO THE PRODUCT
WARRANTY SECTION OF THIS DOCUMENT.