Chicago Gaming Extreme Arcade - Manual (Page 10)

10
Step 7
Remove E1 Monitor from its box and place it on the progressing
assembly. The monitor should be centered between the two cleats
and pushed all the way to the back of the game. Pull the monitor
A/C Cable, VGA Cable and Speaker/Lamp Cable through the
Cable Routing Hole in C4 Monitor Shelf.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.
Step 8
Connect the Monitor A/C Cable, which extends from A2 Control Panel
Assembly to the back of the monitor. Connect the VGA Cable, which
extends from A2 Control Panel Assembly to the VGA cable extending from
the back of the monitor. Plug E2 A/C Cord into the back of A2 Control
Panel Assembly. Temporarily plug the A/C cable into your wall outlet.
Turn the power switch on (located at the front, bottom right side of the
control panel assembly). Confirm system powers up. If monitor does not
turn on, press power button on the monitor. Following the instructions
included with the monitor, center the image and set brightness to 75 (or
whatever setting looks best to you). After you have adjusted the monitor,
unplug the unit from the wall.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.
Step 9
Set C1 Top Left on the progressing assembly. The four H1
Standard Angle Brackets located on C1 Top Left are there only to
help position the part while you install H7 #10-32 x 1-1/4” Truss
Head Screws (no screws will pass through the open holes in the
four H1 Standard Angle Brackets). Be sure to use H8 Nylon
Washer on the screws passing through C1 Top Left. The nylon
washers help protect the artwork (decals) from being damaged by
the screws.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.
Step10
Set C2 Top Right on the progressing assembly. The four H1 Standard
Angle Brackets located on Top Right are there only to help position the part
while you install H7 #10-32 x 1-1/4” Truss Head Screws (no screws will
pass through the open holes in the four H1 Standard Angle Brackets). Be
sure to use H8 Nylon Washer on the screws passing through C2 Top Right.
The nylon washers help protect the artwork (decals) from being damaged
by the screws.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.