Chicago Gaming Extreme Arcade - Manual (Page 9)

9
4.4 Assembly Instructions
Step 1
Lay C7 Right Base Side on any flat surface; including, a
workbench, table or the floor. Place C9 Bottom perpendicular to
C7 Right Base Side. BE SURE TO ORIENT THE GROOVED
SIDE OF C9 IN THE PROPER DIRECTION. Align the
protruding metal tab in H3 Leg Side Bracket into the slots at the
bottom of C7 Right Base Side. Further align the hole in H3 Leg
Side Bracket with the pilot holes in C7 Right Base Side and secure
with H6 #10 x ½” Wood Screw. Only one H6 #10 x ½” Wood
Screw is needed to secure each H3 Leg Side Bracket.
Step 2
Place C5 Base Front in the progressing assembly. Align the holes in the
brackets with the appropriate pilot holes and secure with three H6 #10 x ½”
Wood Screw.
Step 3
Place C6 Left Base Side on the progressing assembly. Align the
holes located in C6 Left Base Side with H3 Leg Side Bracket and
H2 Treaded Angle Bracket and secure with H7 #10-32 x 1-1/4”
Truss Head Screw.
Before tightening screws, force C6 Left Base
Side toward the floor side of the assembly.
Step 4
Place the assembly in its upright position on the floor. Adjust H4 Leg
Leveler to a height that keeps the sides of the assembly off the ground.
Screw H7 #10-32 x 1-1/4” Truss Head Screw through C7 Right Base Side
into H3 Leg Side Bracket.
Step 5
Place A2 Control Panel Assembly onto the progressing assembly
and secure with H7 #10-32 x 1-1/4” Truss Head Screws. Make sure
A2 Control Panel Assembly is centered in the progressing
assembly. Attach H9 Cable Clamp to A2 Control Panel Assembly
with H6 #10 x 1/2” Wood Screw. This will secure the power cord
from coming unplugged from A2 Control Panel Box.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.
Step 6
Place C4 Monitor Shelf onto the progressing assembly. Use C4 Monitor
Shelf to confirm the progressing assembly is square. If the progressing
assembly is not square, you may need to slightly loosen the H7 #10-32 x 1-
1/4” Truss Head Screws that were previously utilized and then force
assembly square. Once the progressing assembly is square, insert H5 #6 x
1-1/4” Wood Screw through C4 Monitor Shelf into the pilot holes in C6
Left Base Side and C7 Right Base Side and tighten down. BE CERTAIN
SCREWS ENTER THE PILOT HOLES.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.