Chicago Gaming Extreme Arcade - Manual (Page 11)

11
Step 11
Set C10 Monitor Glass in the progressing assembly. The painted
side should face toward the inside of the cabinet. The side marked
“TOP” should of course be positioned toward the top. The bottom
of the glass should sit behind the top of the control panel, which
will trap the glass into place.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.
Step 12
SLOWLY and CAREFULLY set A1 Lightbox Assembly on top of the
progressing assembly being careful not to break C10 Monitor Glass. The
front of A1 Lightbox Assembly should sit in front of the glass and trap it in
place. Attach A1 Lightbox Assembly with H7 #10-32 x 1-1/4” Truss Head
Screws. Be sure to use H8 Nylon Washer on the screws passing through C2
Top Right and C1 Top Left. The nylon washers help protect the artwork
(decals) from being damaged by the screws. Connect the Speaker Cable,
which extends from A1 Lightbox Assembly to the remaining cable
extending from A2 Control Panel Assembly.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.
Step 13
Set C8 Base Back in the progressing assembly. Make sure E2 A/C
Cord passes through the opening in the lower left corner of C8
Base Back. Secure C8 Base Back with four H7 #10-32 x 1-1/4”
Truss Head Screws.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.
Step 14
Set C3 Top Back in the progressing assembly. Be sure to position the
ventilation slots toward the top and the tongue toward the inside of the
cabinet. Attach with H7 #10-32 x 1-1/4” Truss Head Screws.
TAKE GREAT CARE NOT TO PINCH ELECTRICAL WIRES AND CORDS. IF
ELECTRICAL WIRES OR CORDS ARE INADVERTENTLY DAMAGED, DO
NOT USE THEM! CONTACT MANUFACTURER FOR REPLACEMENT.
If the unit is not square, C8
Base Back will not fit properly.
Make sure leg levelers are
adjusted properly, loosen screws
and force the unit square.
Out of
Square
Attention Required!