Refer ence man ual, Wir eless fuzzyscan – Cino PL680BT HC User Manual
Page 73
W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
65
PROGRAM
Operation Control
♦ Operation Mode ♦
F_DEFAULT
Family Code Selection
P.C
Parameter Selection
Option Code
Operation Mode
SS
SS
Trigger mode
Presentation mode
1
2
Trigger Mode (Low Power Triggering) the scanner goes into standby state after scanning the bar code. You must press the trigger to turn on the light source of the
scanner before scanning the bar code.
Presentation Mode (Auto Detection) Presentation mode uses ambient light to detect the bar codes. The light source is off until the scanner detects an image which is
similar to a barcode. Then the light source turns on automatically to read the bar code. If the light level in the room is not high enough, Presentation Mode may not work
properly. You can choose different level of “Presentation Sensitivity” to meet your application (Please refer to the setting of “Presentation Sensitivity”).
PF/PL series do not support “Presentation Mode”.