Display Devices Heavy Duty Projector Mount - Manual

1 6/24/05
Installation Instructions
PCM Stationary Mount
Ensure the ceiling structure is capable of holding at least four times the combined weight of the mount, pole
and projector. This is a minimum requirement; follow any local or state codes that apply to your specific area.
Ceiling Mount
Because projectors have different chassis’ (body style, location of lamp & cooling vents) the PCM may have
variations from these instructions. If you are mounting a projector in a facility with sheetrock or other hard
ceiling, follow the directions listed below. If the facility has a drop tile ceiling, skip to the POLE MOUNT section
for installation procedures.
1. Determine exact mounting location based upon the projector’s installation directions. Remove the Upper PCM
(1) by removing hex head hardware from the left and right side of the PCM. Be sure to retain this hardware
for reassembly later.
2. Attach the Upper PCM to the structural ceiling using slotted holes (5). Use appropriate hardware for the
ceiling material and weight involved. If rotational (yaw) adjustment is needed, you may leave this hardware
slightly loose for this purpose. Be sure to secure hardware when completing installation.
3. Mount the projector to the Lower PCM (2) with included hardware. Now reattach the lower PCM to the
Upper PCM using the previously removed hardware. Adjust for proper tilt and yaw, secure all hardware
3b. If your mount is quick release, unscrew the Thumbscrews (3) and remove the Interface Plate (4). Attach the
Interface Plate to the projector with the included hardware. Now reattach the Lower PCM to the Upper PCM
using the previously removed hardware. Attach the projector and Interface Plate with the Thumbscrews.
Adjust for proper tilt and yaw, secure all hardware
1 - Upper PCM
2 – Lower PCM
3 – Thumbscrews
4 – Interface Plate
5 – Mounting holes
5
1
2
1
2
3
5
4
1 – Tilt adjustment
2 – Pitch adjustment