Display Devices AvStack Projector Stackers - Manual

1 5/26/05
5880 Sheridan Blvd., Arvada, CO 80003 - 303/412-0399 - [email protected]
Whether you are mounting this system in a facility with sheetrock or drop-tile style ceiling, you must attach to overhead
structural points that are capable of holding at least four times the combined weight of the AVStack and Projector. This
is a minimum requirement. Follow any local or state codes that apply to your specific area.
1. Begin by determining the exact mounting position of the AVStack frame. Span structural beams with a structural
channel if points are not located precisely above (4) mounting points.
2. Use 3/8” threaded rod to attach to the (4) mounting points on the AVStack. These points are located towards the
corners of the frame. Be sure to use split lock washers, flat washers and upper and lower nuts. If mounting to truss,
use properly-rated c-clamps or cheeseboroughs. The mounting hardware can attach to the slots to canter on an
angle.
Top View
Ceiling Mount Point
Ceiling Mount Point
Installation Instructions
AVStack Mini for Christie Projectors
5880 Sheridan Blvd.
Arvada, CO 80003
303-412-0399
YAW Adjustment
Pitch and height
Adjustment
Pitch and height
Adjustment
Tilt and height
Adjustment
Ceiling Mount Point
Ceiling Mount Point