Installation – Display Devices MFD-100 Microphone Table Lift User Manual

Page 2

Advertising
background image

IP024-027 RevA

MFD-100 Lift Series Installation

4/3/2007


It is the responsibility of the dealer installer to ensure this product is properly supported and
meets all local building codes. DO ensure the table structure is capable of holding at least
four times the combined weight of the MFD. This is a minimum requirement. Follow any local
or state codes that apply to your specific area.

The MFD-100 is a furniture-mounted, motorized rotator which “flips” to reveal a hidden microphone or
other small device from inside a table. It is designed for integration into boardroom / classroom tables.
The MFD-100 can be fitted with material from your table so it sits flush with the table top. Weight load
capacity is 3 lbs.

Tools required:

Philips-head Screwdriver
Drill
Wire-management tools (crimper, etc.)
7/64” Allen wrench
Magnetic tape, double-stick tape to attach table surface to rotator

Installation

Figure A


1.)

Determine the orientation of rotation for the MFD-100/50 based on the size of the microphone being

used and the size/style of the table in which it will be installed.

2.)

Have a professional mill worker cut an 8.25” x 6.25” hole in the conference table based on the

orientation you’ve chosen. The bottom of the hole should be undercut with a route at a 45 degree
angle in the direction of rotation (as shown in Figure C). Be sure to allow enough clearance from
the edge of the table to fit the entire assembly and cabling. The MFD-100 is designed to mount to a
table top no more than ½” thick. If the table top is more than ½” thick, have the mill worker router
out a pocket that is at least 13.28” x 10.75” to house the unit.

3.)

Before attaching the unit to the table, unscrew the four screws and remove the top plate from the

unit (as shown in Figure B, below). This is the surface to which the matching tabletop and
microphone/speaker will be affixed.



Advertising