Display Devices MFD-100 Microphone Table Lift - Manual (Page 5)

IP024-027 RevA
MFD-100 Lift Series Installation
4/3/2007
Using the Remote Control
Use the included hand-held remote control unit to initially setup and test the MFD-100. If operating the
MFD from a control system, remove the hand-held control and integrate momentary contact closure to
pins 1 through 4.
There are three buttons on the remote control unit: “HOME,” “SHOW,” and “STOP.”
HOME: Unit rotates to the stored position and the microphone/speaker is hidden.
SHOW: Unit rotates to the up position and the microphone/speaker is revealed.
STOP: Unit rotation stops.
Programming Positions
Enter Manual Mode: hold STOP for ten seconds – LED on the internal circuit board will flash
Press SHOW to rotate to the show position. Press STOP at the desired position. If you rotate farther
than needed, rotate backwards pressing HOME and STOP at the appropriate position.
To save this position - Press and hold STOP then press and hold SHOW – when LED flashes release
SHOW, then release STOP.
Press HOME to rotate to the home position. Press STOP at the desired position. If you rotate farther
than needed, rotate backwards pressing SHOW and STOP at the appropriate position. To save this
position – Press and hold STOP then press and hold HOME – when LED flashes, release HOME, then
release STOP.
Press and hold STOP – wait for the LED to flash, release. Unit is now programmed.