Dream Property DM7080 HD - Manual (Page 10)

1.3.2 Rear view
Power
Made in Taiwan
USB 3.0 S/PDIF HDMI-Out HDMI-In USB 2.0 Ethernet Service SD-Card
Tuner B
Tuner
A2 A1
Tuner C
ON
OFF
Power switch
Power connector
LNB input A2
LNB input A1
2x USB 2.0
port
Service connector
SD Card slot
Network interface
HDMI input
HDMI output
USB 3.0
port
S/PDIF
Power switch The main power switch shuts off power from your Dreambox.
!!! IMPORTANT !!!
Before opening the device, always pull the power plug!
Power connector Plug the power cable into the main power socket. You must not connect the power plug
to anything other than a socket that supplies 110V/60Hz or 230V/50Hz.
1 x USB 3.0 port The USB 3.0 Port is designed for devices that support the USB 3.0 standard. The amount
of supported USB devices depends on the installed image (Software) and is still under development.
S/PDIF optical audio You can connect your Dreambox with an optical (Toslink) cable to your HiFi-
Amplifier or DSP. The AC3 signal is also available at this port in case the selected channel transmits
Dolby Digital signals.
HDMI ® -Out output You can connect a TV to the HDMI ® out of your Dreambox if your TV has the right
input.
HDMI ® -In input You can connect your HDMI ® device with the right output.
2 x USB 2.0 port The USB 2.0 Port is designed for devices that support the USB 2.0 standard. The amount
of supported USB devices depends on the installed image (Software) and is still under development.
Network interface The Communication Port is an Ethernet port. It is used to communicate with your
Dreambox via HTTP, FTP, NFS, Telnet, SSH and Samba to access your recorded movies, to upload
channel lists, etc. This port is also used to update the operating system of your Dreambox. Please
use a regular patch cable to connect your Dreambox to your LAN.
Service connector The Service port is used to update the operating system. Please connect a mini-usb-to-
usb-cable here.
SD-Card Reader Put your SD-card e.g. from your digital camera in here.
5