Dream Property DM7080 HD - Manual (Page 57)

2. With the Navigation-Buttons ( ) choose the option “Setup” and press the OK-Button.
3. With the Navigation-Buttons ( ) choose the option “Network” and press the OK-Button.
4. With the Navigation-Buttons ( ) choose the option “Network Setup” and press the OK-Button.
5. Use the Navigation-Buttons and the Numeric-Keypad to change the settings.
Wired This option toggles the integrated ethernet interface on and off.
Manually setting an IP address
These settings are only needed if you want to configure your Network manually.
1. With the Navigation-Buttons (
)
choose the cable based network “Wired” and press the OK-
Button
.
2. Press the yellow Options-Button.
3. With the Navigation-Buttons (
)
choose the option "‘Method (IPv4)"’ and press the OK-
Button
.
4. With the Navigation-Buttons (
)
choose the option "‘manual"’ and press the OK-Button.
Address (IPv4) Enter the IP address here.
Free IP-Addresses: 192.168.0.2 - 192.168.0.254
Mask (IPv4) Enter the subnet mask (Usually 255.255.255.0).
Gateway (IPv4) Enter the router’s IP address here, if the Dreambox is connected to the Internet by a
router.
Usually this is: 192.168.0.1
To save the settings and activate the network connection press the OK-Button.
DNS-Settings
1. With the Navigation-Buttons (
)
choose the cable based network “Wired” and press the OK-
Button
.
2. Press the blue Options-Button to open the DNS-Settings dialog.
The colored buttons in this menu are mapped to the following functions:
red Options-Button Delete selected nameserver.
green Options-Button Add IPv4-nameserver.
yellow Options-Button Add IPv6-nameserver.
blue Options-Button Skip changes.
Nameserver Enter the DNS-Server’s IP address here. DNS is used to translate a Domain name to an IP
address. Normally, if the Type is set to LAN, there is no need for a DNS entry. If the Dreambox is
connected to the Internet over a router, enter the router’s IP address here.
52