Dream Property DM7000 - Manual (Page 36)

- 36 -
35.2. Communication (Network, WAN (DSL) Setup)
Press the DREAM-Button to enter the OSD-Mainmenu.
Go to (6) Setup -> (6) Expert Setup -> (1) Communication Setup.
Navigate to Type, press the OK-Button and select
WAN(PPoE). Use this Type of Connection only, if
the Dreambox is connected directly to a DSL-
Modem.
T-DSL is used to enter the Account information only
for german T-Com users.
Login:
Enter the Loginname provided from your ISP
(Internet Service Provider).
Password:
Enter the Password provided from your ISP.
The Dreambox provides firewall functionallities on
the following Ports:
80 HTTP, 23 Telnet, 137, 138, 139 Samba and 21
FTP. Uncheck the desired Checkbox to allow
incoming connections.
35.3. NGrab Streaming Setup
Press the DREAM-Button to enter the OSD-Main menu.
Go to (6) Setup -> (6) Expert Setup -> (2) Ngrab Streaming Setup.
The MAC-Address is used for the WOL (Wake
On LAN) funktion, which must be supported by
the PC’s NIC (Network Interface Card). This is
a pretty good feature, because you can
configure a PC to use full APM (Advanced
Power Management). The PC awakes upon
access through the NIC and the Ngrab
recording starts.
Ngrab Server is used to record a movie over the
Network to another PC. First install the Ngrab
Server Software on a PC and configure it referring
the manual from the Software.
Srv IP:
Enter the IP-Address of the PC on which the Ngrab
Server Software runs.
Srv Port:
Enter the Server Port-Address which is configured
in the Ngrab Server Software.
Srv MAC:
The Ngrab Server Software must be started and
configured, before detecting the MAC-Address of
the PC. Press the blue Option-Button to start
detecting.
Press the green Option-Button to save.