Dream Property DM7000 - Manual (Page 53)

- 53 -
43.1. DreamUp - Preparing DreamUp
Start the Software DreamUp2.14b on your PC.
Choose the COM Port, which is connected to the Dreambox.
Make shure the Checkbox „Use Network“ is checked. If not, the Software connects only serial.
Type in the IP-Address from your PC „Local IP (PC)“.
Type in an IP-Address „Remote IP (Box)“ for the Dreambox, e.g. 10.0.0.97.
Make sure the IP-Address is not assigned to another Computer in your LAN, if the Dreambox is
connected over a Hub, Switch or Router with an normal Pathcable.
If you are using a Crossover Patchcable to connect, then the IP-Adddress is not that important, but it
must match to the chosen Subnetmask.
Dreamup is now prepared for flashing the image.