Dream Property DM820 HD - Manual (Page 10)

1.3.2 Rear view
LNB input Connect the coaxial cable from your LNB here.
Micro SD-Card Reader Put your Micro SD-card e.g. from your digital camera in here.
HDMI ® -Out output You can connect a TV to the HDMI ® out of your Dreambox if your TV has the right
input.
HDMI ® -In input You can connect your HDMI ® device with the right output.
S/PDIF optical audio You can connect your Dreambox with an optical (Toslink) cable to your HiFi-
Amplifier or DSP. The AC3 signal is also available at this port in case the selected channel transmits
Dolby Digital signals.
Power switch The main power switch shuts off power from your Dreambox.
!!! IMPORTANT !!!
Before opening the device, always pull the power plug!
2 x USB 2.0 port The USB 2.0 Port is designed for devices that support the USB 2.0 standard. The amount
of supported USB devices depends on the installed image (Software) and is still under development.
eSATA connector You can connect an external SATA Hard disk.
Network interface The Communication Port is an Ethernet port. It is used to communicate with your
Dreambox via HTTP, FTP, NFS, Telnet, SSH and Samba to access your recorded movies, to upload
channel lists, etc. This port is also used to update the operating system of your Dreambox. Please
use a regular patch cable to connect your Dreambox to your LAN.
Service connector The Service port is used to update the operating system. Please connect a mini-usb-to-
usb-cable here.
Power supply connector Plug the power cable of the power supply that came with your Dreambox into
power outlet. Connect your power supply to your Dreambox. You must not connect the power plug
of the power supply to anything other than a socket that supplies 230V/50Hz.
5