EarthQuake 3200 - Manual (Page 14)

14
ARDISAM
TILLING
1. Adjust the depth regulator lever to desired tilling depth.
NOTE: Raise depth regulator lever up one hole at a
time, testing tiller operation after each raise. Raising
depth regulator lever too high can result in loss of
control of tiller!
2. Move the throttle control to fast .
3. Place the tiller in forward by pushing down on the
drive control lever--this will engage the tines.
To stop the engine at any time, move throttle
control to the off position. To stop tines at any
time, release drive safety control lever to the
neutral position.
OPERATION
SHUTTING DOWN
Temperature of muffler and near by areas may
exceed 150
° F. Avoid these areas.
Do not move choke control to CHOKE to stop
engine. Backfire or engine damage may occur.
To stop the engine at any time, move throttle control
to the off position. To stop wheels and tines at any
time, release drive safety control levers to neutral
position.
WARNING
WARNING
Engine and surrounding parts become extremely
hot during normal use, and will cause serious burn
injuries if touched before the engine has cooled.
Allow engine to cool completely before touching
these hot surfaces.
DANGER
WARNING
Do not move choke control to CHOKE to stop
engine. Backfire or engine damage may occur.
CAUTION
To stop the tines at any time, release drive safety
control lever to the neutral position.
CAUTION
Always release drive safety control lever to the
neutral position before adjusting the depth regulator
lever.
CAUTION