Eurocom D270ES VIPER - Manual (Page 78)

Advanced Controls
Adjusting Monitor Settings 3 - 15
3
Adjusting Monitor Settings
If you prefer to use a VGA monitor (CRT) you may change the vertical re-
fresh rate from the following control panel. Double-click on the VGA
monitor icon (in the example below it is the icon as the VGA is set for
Display_2).

Vertical Refresh Rate
The vertical refresh rate
of your CRT is impor-
tant. If it is too low and/
or you’re using fluores-
cent lighting, the screen
will appear to flicker. To
reduce flickering on a
CRT, use faster refresh
rates (we recommend a
refresh rate of 72Hz or
more). But first check
your monitor’s docu-
mentation to make sure
it can support the rates
listed by the video driv-
er. The default refresh
rate for VGA monitors
(without drivers) is
60Hz.
Figure 3 - 9
Monitor
Properties
2
Double-Click on the VGA Monitor icon and select the Monitor (tab)