EXFO AXS-200 SharpTESTER - Manual (Page 30)

Customizing Your SharpTester
22 AXS-200
Setting Network Connection Parameters
Setting Network Connection Parameters
It is possible for you to manually set the IP settings for the Ethernet ports on
your unit.
To configure the network connection settings:
1. Press ,
select System, then Settings, and then Network
Connection.
2. Enable the DHCP to dynamically
obtain an IP address from a DHCP
(Dynamic Host Configuration
Protocol) server. DHCP is enabled
by default.
OR
If DHCP is disabled, enter the IP
address, subnet mask address, and
default gateway address for the
Ethernet port by selecting them individually, pressing
, and entering
the values directly.
3. Press Apply to activate the new network connection settings.