EXFO FOT-930 Multifunction Loss Tester - Manual (Page 27)

Customizing Your Multifunction Loss Tester
Multifunction Loss Tester 19
Adjusting the Brightness and Contrast
Adjusting the Brightness and Contrast
To fit your work environment, you may adjust the LCD brightness and
contrast. Values are kept in memory when you turn the unit off. You may
also
revert to factory settings at any time.
Note: These settings do not apply to the Fiber Inspection Probe display. For
details, see Inspecting Fibers with the FIP on page 63.
To adjust the display brightness and contrast:
Press the
key repeatedly to switch between brightness levels (0-4-7-10).
OR
1. Press Menu, then select Setup > Unit.
2. Press Next Tab (F1/F2 key) until you get to
the LCD tab.
3. Use the up/down arrows to select the
Brightness or Contrast slider.
4. Use the left/right arrows to adjust the
brightness or contrast level.
To revert unit to factory-default settings:
1. Press Menu, then select Setup > Unit.
2. Press Factory Settings (F1/F2 key). Values on all tabs of the Unit Setup
pane are returned to factory settings.