EXFO MaxTester MAX-610 - Manual (Page 10)

Introducing the MaxTester MAX-610
2 MAX-610
Typical Applications
Typical Applications

Auto tests including POTS Auto Test

Multimeter tests

Noise tests including power influence, PSD, and attenuation analysis

Frequency tests including balance, load coils, and locator tone

Fault location tests including TDR and RFL

SmartR™ features including Pair Detective and FaultMapper
Using the MAX-610
The MAX-610 is tested for IP54 compliance which means that it is not
affected by dust or water splashing against the enclosure from any
direction. This protection is only valid when both side doors are properly
closed. If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be impaired.
The MAX-610 is equipped with a series of interfaces shown in the following
views:

Left
USB Host Port
USB Client Port
SD Card (not used)
Head Set Jack (2.5 mm)
Door