Glow-worm Black Beauty 4 - Manual (Page 15)

15 221906B
7 Final Review
Please ensure the “Benchmark” logbook (supplied with Back
Boiler Unit) is completed and left with the user.
Check the operation of the fire at all control positions.
Visually inspect the appliance. Clean off any marks incurred
during installation.
Advise the customer how to operate the fire and boiler.
Explain to the customer that the appliance has a flame failure
and spillage monitoring system. Point out the explanation of this
system in the "Instructions for Use".
Advise that if the appliance goes out for any reason, they must
wait at least three minutes before relighting.
Stress that if the monitoring system repeatedly shuts off the
appliance that it must be switched off and their local installation
or service organisation must be contacted or the local gas
undertaking contacted.
Advise the user that the glass may require cleaning periodically
outside and inside as described in the users instructions.
Explain how to remove and replace the glass panel assembly
for cleaning the inside of the glass etc. Point out that a tool is
supplied for releasing the screws. Leave the tool in the instruction
pack.
Advise that the fire may give off a slight odour while new. This
is quite normal and it will disappear after a short period of use.
Advise the customer that they should read the Instructions for
Use before operating the fire and always follow the advice in the
section headed "Cleaning your fire".
If using the appliance for long periods it is beneficial to change
between settings. This will also help to remove any carbon
deposits that may form during use.
Recommend that the appliance should be serviced and the
chimney inspected by a competent person (In the UK a CORGI
registered person) at least annually.
If the appliance is in premises in the United Kingdom occupied
by a tenant, point out that by law a landlord must have any gas
appliance, flue and pipework which is situated in a tenant’s
premises checked for safety at least every 12 months.
Reminder- leave these instructions and the “Benchmark” logbook
with the user.