Glow-worm Black Beauty 4 - Manual (Page 6)

6 221906B
Cleaning
Turn the fire off and allow it to cool before attempting any
cleaning.
Normally the fire will only need dusting. The bright metal trims
may be cleaned with a damp cloth and dried with a soft duster.
Obstinate marks can be removed from the trims using soapy
water. Never use abrasive cleaners.
Glass Panel
Remove any stains on the glass with a non-abrasive cleaner
such as a ceramic hob cleaner. Do not use abrasive cleaners.
The fire has been designed to so that you can remove the glass
panel without having to call in a service engineer. This allows
you to clean the inside of the glass.
To remove the glass panel assembly:
Detach the glass panel surround by sliding it upwards and then
swinging the bottom forwards. Lift and store carefully. See
diagram 5.
Remove the glass panel assembly by turning the screws each
side of the frame
1 /
4
turn anticlockwise. A tool is provided with
your fire for turning the screws. Lift the assembly clear, see
diagram 5.
After cleaning, replace and secure the glass panel assembly to
the firebox by turning the two screws
1 /
4
turn clockwise with the
tool provided. Refit the surround by sliding it upwards to locate
its upper tabs in the slots underneath the outer case hood. Push
the bottom of the surround fully against the case cross panel.
Drop the surround down so that the two screw heads at the back
of the surround locate in the cross panel, see diagram 7.
Ceramic Coal
This product uses a fuel effect piece containing Refractory
Ceramic Fibres (RCF), which are man-made vitreous silicate
fibres. Excessive exposure to this material may cause temporary
irritation to eyes, skin and respiratory tract. Consequently, it
makes sense to take care when handling this article to ensure
that the release of dust is kept to a minimum.
Although light coatings of soot are usually burnt off during
normal use, the coal may benefit from occasional cleaning.
Should any soot accumulation become excessive, the fuel
effect piece should be removed from the fire for cleaning.
Cleaning should be carried out in a well ventilated area or in the
open air by gently brushing with the pieces held away from your
face so that you avoid inhaling the dust. We do not recommend
the use of a normal domestic vacuum cleaner which may blow
dust back into the air.
The coal can be lifted out of the fire box when the glass panel
surround and glass have been removed as described above.
When replacing the coal, make sure that it rests on the ledges
at the sides of the firebox and that its back face is touching the
horizontal rib at the back of the firebox, see diagram 8.
Replace the glass panel assembly and surround after cleaning.
Replacement Parts
If replacement parts are required apply to your local supplier.
Please quote the name of the appliance and Part No. required.
Diagram 8
9489
FIREBOX
BACK RIB
Instructions for Use
SIDE
LEDGE
SIDE
LEDGE
SIDE
VIEW
FUEL BED
Diagram 7
9510
KEYHOLE
SLOT
LOCATING
TABS
GLASS PANEL
SURROUND