Glow-worm Black Beauty 4 - Manual (Page 9)

9 221906B
4.1 Unpacking
The carton contains the following:-
1. Fire assembly.
1. Ceramic fuel effect (In packaging inside firebox).
1. Fittings pack.
1. Gas feed pipe and fittings.
1. Literature pack.
1. Tool for window removal.
Remove all the items carefully to prevent damage. Some items
may be contained in the packaging fitments. Examine the
packaging carefully before discarding. Check that all the items
are present and undamaged.
4.2 Appliance Preparation
Stand the fire upright.
Remove the two transit screws from the upper back panel, see
diagram 4.1.
Detach the glass panel surround by sliding it upwards and then
swinging the bottom forwards, see diagram 5 Instructions for
Use.
Remove the control knob by pulling clear of the gas tap spindle.
Remove the control bezel by unscrewing two screws see
diagram 4.2.
Detach the outer case by removing the screws at the case sides
see diagram 4.2.
Pull the bottom of the case forwards while springing the bottom
corners outwards to clear the fixing brackets. Lift the case
upwards and forwards to clear . Place carefully to one side.
IMPORTANT : The front fascia of the case is secured by two
screws as shown in diagram 4.1a. These screws have been
tightened to avoid damage to the case during transit. These
screws must be slackened to enable the customer to
remove this section of the case.
Remove the window unit by turning the screws each side of the
glass panel assembly
1 /
4
turn anticlockwise and lifting clear, see
diagram 7 Instructions for Use.
Remove the fuelbed from the firebox and keep it safe.
4 Fire Front Preparation
Diagram 4.2
CONTROL
BEZEL
RETAINING
SCREW (2)
OUTER CASE
SECURING SCREW (2)
9561
Diagram 4.3
9640
GAS FIRE
FEED PIPE
UNION
NUT
GAS FIRE
SUPPLY
COCK
GAS FIRE
SUPPLY
COCK
CAP
RESTRICTOR
SCREW
WASHER
GAS
SERVICE
COCK
Diagram 4.1
10175
10171
WINDOW SURROUND REMOVAL Diagram 4.1A
TRANSIT
SCREWS